14/LIGHT SYSTEM, INSTRUMENTS 67
700295-01
– Disconnect plug-in connector .
– Push off the retaining clamp on both sides, squeeze and fold to the side.
– Remove headlight bulb .
700296-01
– Position the new headlight bulb in the headlight housing.
Low beam / high beam (H7) ( p. 169)
Info
Insert the headlight bulb so that the lug is positioned in the cut-out.
– Position the retaining clamp.
– Position the plug-in connector.
400422-10
– Position the lug of the lamp cover in the notch. Engage the latch .
– Check lighting function.
700293-11
– Position the rubber holder .
– Fold down the combination instrument. Position the lug in the rubber holder.
17.16Change the high beam bulb.
Note
Damage to reflector Keep the glass of the bulb free of grease.
– Clean the glass bulb with a clean cloth before mounting. Any grease on the glass will evaporate by the heat and be deposited on
the reflector.
– Switch off all power-consuming components and switch off the engine.
To Next Page
Loading...
