34/SHIFT MECHANISM 143
2334/SHIFT MECHANISM
23.1Adjusting shift lever stub
700304-01
– Remove the screw with the shift lever stub.
– Position the shift lever stub with the screw in one of the holes according to the
desired lever length.
Guideline
Standard Central hole
– Tighten screw.
Guideline
Screw, shift lever stub M6 10 Nm
(7.4 lbf ft)
Loctite
®
243™
23.2Adjusting shift lever
Info
The footrest system offers many ways of adjusting the shift lever to your riding style and requirements.
700343-01
– Remove screws and take off the shift rod.
– The length of the shift rod can be adjusted by means of the screw thread.
Guideline
Shift rod 115… 130 mm (4.53… 5.12 in)
– Loosen the counter nuts .
– Adjust the shift shaft.
Info
Make the same adjustments on both sides.
After the counter nuts have been tightened, the bearings of the shift shaft
must be central and aligned identically to each other in order to ensure free-
dom of movement in the bearing shells.
At least 5 screw threads must be screwed into the seating.
– Tighten the counter nuts.
To Next Page
Loading...
