30/DISASSEMBLING THE ENGINE 84
19.23Removing the oil filter
200481-10
– Remove screws . Take off oil filter cover with the O-ring.
– Pull oil filter element out of the oil filter case.
Circlip pliers reverse (51012011000) ( p. 195)
19.24Removing the balancer shaft
200356-10
– Remove balancer shaft with washer .
– Mount the needle bearing and the rear washer.
19.25Removing the drive wheel of the balancer shaft
200358-10
– Remove the drive wheel of balancer shaft using special tool , and .
Extractor (78029033100) ( p. 202)
Pressure piece (61229018000) ( p. 200)
Arms for extractor 78029033100 (61229017000) ( p. 200)
19.26Removing the gear position sensor
200359-10
– Remove the screws. Remove gear position sensor with the O-ring.
To Next Page
Loading...
