KTM 1190 RC8 EU 2008 - Work on the Left Section of the Engine Case

30/ENGINE - WORK ON INDIVIDUAL PARTS 94
– After the engine case section has cooled, check that the bearings are firmly seated.
Info
If the bearings are not firmly seated after cooling, it is likely that they will
rotate in the engine case when warm. In this case, the engine case must be
renewed.
– Mount and tighten bearing retainers .
Guideline
Screw, bearing retainer M5 6 Nm
(4.4 lbf ft)
Loctite
®
243™
200440-10
– Mount and tighten jet .
Guideline
Jet 140 M6x0.75 4 Nm
(3 lbf ft)
Loctite
®
243™
– Mount and tighten oil jets .
Guideline
Oil jet M6x0.75 4 Nm
(3 lbf ft)
Loctite
®
243™
– Mount the dowels.
200442-10
– Mount studs .
Guideline
Stud, chain shaft M6 8 Nm (5.9 lbf ft)
– Blow compressed air through all oil holes and check that they are clear.
20.2Removing the main bearing of the right engine case section
200435-10
– Remove the screws and take off bearing shell bracket .
200436-10
– Mark face  of the main bearing shells as shown in the figure.