08/MASK, FENDER, DECAL 37
200495-12
– Remove screw .
– Remove the screws of the EFI control unit . Unplug and remove the EFI control
unit.
– Unplug the control unit of the electric starter lock .
– Remove the overflow hose. Take off the right inside cover.
12.4Installing the inside cover
200495-11
– Position the right inside cover. Mount and tighten screw .
– Position the overflow hose.
– Plug in EFI control unit and position it. Mount and tighten the screws.
– Plug in the control unit of the electric starter lock .
200494-11
– Position the left inside cover. Mount and tighten screw .
– Connect the plug-in connectors to generator and ignition pulse generator .
– Screw ground wire onto the frame.
Guideline
Remaining chassis screws M6 10 Nm (7.4 lbf ft)
200537-11
– Mount and tighten screws .
200493-11
– Mount expanding rivets .
– Install the side covers. ( p. 36)
– Connect the negative (minus) cable of the battery.
– Fit the seat. ( p. 32)
To Next Page
Loading...
