30/ASSEMBLING THE ENGINE 131
21.26Installing the torque limiter and idler
200347-11
– Mount the rear washer, needle bearing, idler and front washer.
– Mount torque limiter with the rear washer.
21.27Installing the ignition pulse generator
200346-10
– Position the ignition pulse generator .
– Mount and tighten the screws.
Guideline
Screw, pulse generator M5 10 Nm
(7.4 lbf ft)
Loctite
®
243™
– Position the cable, thinly coat cable support sleeve with the sealing compound
and insert it in the engine case.
Loctite
®
5910
– Check the distance between the ignition pulse generator and rotor.
Guideline
Ignition pulse generator - conductive
element/rotor clearance
0.70 mm (0.0276 in)
21.28Installing the generator cover
200344-10
– Mount the new generator cover seal and dowels.
– Position the generator cover.
– Mount and tighten screws .
Guideline
Remaining engine screws M6 10 Nm (7.4 lbf ft)
21.29Installing the oil drain plug
200480-10
– Mount the new O-rings.
– Mount and tighten oil drain plug with the magnet, O-rings and oil screen.
Guideline
Oil drain plug M20x1.5 20 Nm
(14.8 lbf ft)
To Next Page
Loading...
