11/WIRING HARNESS, BATTERY 52
15.5Changing the fuses of individual power consumers
Warning
Fire hazard The electrical system can be overloaded by the use of incorrect fuses.
– Use only fuses with the prescribed amperage. Never by-pass or repair fuses.
Info
The fuse box containing the fuses of individual power consumers is located under the seat.
– Switch off all power-consuming components and switch off the engine.
– Remove the seat. ( p. 32)
700281-01
– Open fuse box cover .
700282-01
– Check the fuses.
Info
A defective fuse is shown by a burned-out fuse wire .
– Remove the defective fuse.
Guideline
Fuse 1 - 10A - ignition, combination instrument, immobilizer, alarm system
(optional)
Fuse 2 - 15A - high beam, low beam, parking light, tail light, license plate lamp
Fuse 3 - 10A - horn, brake light
Fuse 4 - 10A - radiator fan
Fuse 5 - 10A - fuel pump
Fuse 6 - 10A - ignition/fuel injection
Fuse 7 - not used
Fuse 8 - 10A - for supplementary equipment (standard accessories)
Fuse 9 - 10A - for supplementary equipment (accessories connected to the igni-
tion switch)
Fuse 10 - not used
Fuse SPARE - 10A/15A - spare fuses
– Use spare fuses with the correct rating only.
Fuse (75011088010) ( p. 168)
Fuse (75011088015) ( p. 168)
Info
If the new fuse burns out after it is inserted, it is important that you contact
an authorized KTM-RC8 workshop.
Tip
Replace the spare fuse in the fuse box so that it is available if needed.
– Close the fuse box cover.
– Fit the seat. ( p. 32)
To Next Page
Loading...
