10/REAR WHEEL 43
700313-01
– Remove bushing and bushing . Clean and grease the roll surfaces of the bush-
ing and the shaft seal rings.
Long-life grease ( p. 194)
– Mount the bushings.
– Clean the thread of the wheel spindle and nut.
– Clean the contact areas of the brake caliper support and swingarm.
700314-01
– Push the brake caliper support completely to the rear.
– Position the rear wheel, and position the brake caliper support between the rim and
the brake disc.
– Position the brake caliper on the brake disc.
– Position the rear wheel on the bearing surfaces in the swingarm.
700315-01
– Push the rear wheel forward as far as possible and place the chain on the rear
sprocket.
– Pull the rear wheel back and push in the wheel spindle.
700316-01
– Lay the chain adjuster on the tensioning screw.
– Position chain adjuster and place it on the tensioning screw.
– Tighten nut .
Guideline
In order for the rear wheel to be correctly aligned, the markings on the left and
right chain adjusters must be in the same position relative to reference marks .
Nut, rear wheel spindle M25x1.5 90 Nm
(66.4 lbf ft)
Thread greased
– Operate the foot brake lever repeatedly until the brake linings lie on the brake disc
and there is a pressure point.
– Check the chain tension. ( p. 45)
To Next Page
Loading...
