06/AIR FILTER 29
200498-10
– Unplug the connector of the manifold absolute pressure sensor .
– Take the manifold absolute pressure sensor out of the holder but do not detach the
vacuum hoses.
– Disconnect plug-in connector .
– Take plug-in connector out of the holding bracket.
200499-10
– Remove screws . Take off the retaining plates and holding brackets.
– Remove screw . Remove the cover.
200500-10
– Loosen hose clamps .
200501-10
– Loosen the spring-loaded band-type clamp using the special tool. Pull off the
fuel hose.
Pliers for spring-loaded band-type clamp (60029057100) ( p. 197)
– Pull up the throttle valve body and remove connector with the seal.
– Pull the Bowden cables out of the filter box bottom with guide piece .
– Raise the throttle valve body at the front and fix it on the handlebar.
200502-10
– Remove rubber sleeves .
200503-10
– Raise the filter box bottom and pull off drain hoses .
– Detach the connector of the intake air temperature sensor.
– Remove snorkel seals .
– Raise the filter box bottom at the front and fix it on the handlebar.
To Next Page
Loading...
