Kyocera 408ci - Page 117

2-47
Installing and Setting up the Machine > Quick Setup Wizard
1
Display the screen.
[System Menu/Counter] key > [Quick Setup Wizard]
2
Select a function.
3
Configure the settings.
Start the wizard. Follow the instructions on the screen to configure settings.
Network Setup Configures network settings.
Network Network Selection
Wi-Fi
*6
DHCP
*7
IP Address
*8
Subnet Mask
*8
Default Gateway
*8
Email Setup Set SMTP server name and sender address to enable mail sending.
Email SMTP (Email TX)
SMTP Server Name
*9
SMTP Port Number
*9
Sender Address
*9
*1 This is displayed when the option of two FAX Kits has been installed.
*2 Inch version only.
*3 DRD reception mode is available for some countries.
*4 This setting does not appear in some regions.
*5 This function is displayed when [Weekly Timer] is set to [On].
*6 This function is displayed when [Network Selection] is set to [Wi-Fi].
*7 This function is displayed when [Network Selection] is set to [Wired Network].
*8 This function is displayed when [DHCP] is set to [Off].
*9 This function is displayed when [SMTP (Email TX)] is set to [On].
NOTE
If the user authentication screen appears, enter your login user name and login password and select [Login].
The factory default login user name and login password are set as shown below.
NOTE
If you experience difficulty configuring the settings, refer to the following:
Help Screen (page 2-28)
Control Description
End Exits the wizard. Settings configured so far are applied.
Previous Returns to the previous item.
Model Name Login User Name Login Password
358ci 3500 3500
408ci 4000 4000
508ci 5000 5000