Kyocera 408ci - Page 443

8-60
Setup and Registration (System Menu) > System Menu
REST over SSL Protocol
Settings
Select whether to communicate using REST over SSL.
*1*2
Value: Off, On, 1 to 32767 (Port Number)
NOTE
When selecting [On], it also requires a certificate for SSL. the default certificate
is the self-certificate of the machine.
Command Center RX User Guide
Available
Network
Set whether to enable this function for each network of Wi-Fi Direct, Wi-Fi and
wired.
Value: Disable, Enable
VNC (RFB) Protocol
Settings
This is set when starting up a VNC Viewer (E.g. RealVNC) to use the Remote
Operation.
*1
The default port number is 9062.
Value: Off, On, 1 to 32767 (Port Number)
Available
Network
Set whether to enable this function for each network of Wi-Fi Direct, Wi-Fi and
wired.
Value: Disable, Enable
VNC (RFB) over
SSL
Protocol
Settings
This is set when starting up a VNC Viewer (E.g. RealVNC) to use Remote
Operation protected by SSL.
*1*2
The default port number is 9063.
Value: Off, On, 1 to 32767 (Port Number)
NOTE
When selecting [On], it also requires a certificate for SSL. The default
certificate is the self-certificate of the machine.
Command Center RX User Guide
Available
Network
Set whether to enable this function for each network of Wi-Fi Direct, Wi-Fi and
wired.
Value: Disable, Enable
Enhanced VNC
over SSL
Protocol
Settings
This is set when starting up Command Center RX to use Remote Operation
protected by SSL.
*1*2
The default port number is 9061.
Value: Off, On, 1 to 32767 (Port Number)
NOTE
• The default setting is [On].
• When selecting [On], it also requires a certificate for SSL. The default
certificate is the self-certificate of the machine.
Command Center RX User Guide
Available
Network
Set whether to enable this function for each network of Wi-Fi Direct, Wi-Fi and
wired.
Value: Disable, Enable
*1 The setting will be changed after restarting the device or network.
*2 Set "SSL" to [On] in Security Settings.
SSL
(page 8-77)
Item Description