zero.
4. Connect the cable clone box between the unit’s SDI In and the SDI source. Select
300M and run the EDH test for 2 minutes. (Press RESET on the WFM601 to
start the timer). The EDH light on the unit will flash if errors are detected.
Timing and General
1. Cycle through all input video sources, and observe composite, S-Video, analog
component and SDI outputs on appropriate waveform monitors to ensure they are
within spec.
2. Select the Horizontal option in the Timing Setup menu. Use the control knob to
adjust this option to line up the output sync falling edge with the black reference
sync edge.
3. Select the Subcarrier option in the Timing Setup menu. Use the control knob to
adjust this option to line up the output burst with the black reference burst.
DV Module Check
1. Install the DV I/O Module, as detailed in Appendix C, “Installation of Hardware
Options.” Be sure to install the cable between the DV I/O Module and connector
NHE1.
2. Connector a PAL DV Camcorder or a DV deck to DV I/O on the back of the unit.
3. Play and record a clip to check that DV video and audio are working.
110
DPS-475/575 Service Manual
To Next Page
Loading...
