Appendix D
APPENDIX D: THE UPLOADER SOFTWARE
The Uploader software, which runs on Microsoft Windows 95, 98, and NT 4.0, is
used to perform firmware upgrades to the DPS-475 and DPS-575, and to transfer
video stills and animations to the unit from the PC.
Be sure to check the DPS web site (www.dps.com) frequently for
updates to the Uploader software, and for updated firmware for the
unit.
This section assumes that you have a working knowledge of the Windows operating
system, and that the RS-232/422 port of the DPS unit is connected via a serial cable
to one of the RS-232 serial ports on your PC.
Software Installation
1. If you have downloaded the Uploader software from our web site, unZIP the file
into a directory on your hard drive. (The ZIP file format is a compressed format
commonly used for file distribution; utilities to uncompress ZIP files are readily
available on the web).
2. Open the directory you unZIPed into in step 1 (or the CD-ROM containing the
Uploader software), and double-click on the Setup icon. The installer will run.
3. Follow the on-screen instructions to install the software onto your system. You
may accept the default locations for the software to be installed on your system,
or select a directory of your choice. The software will be copied to the
appropriate location, and you will be prompted when installation is complete.
Starting the Software
The Uploader software is started by selecting it from the Programs menu of the
Windows Start button. You will find the software in the Start > Programs > DPS >
Uploader. You can run the program from here, or create a shortcut to it on your
desktop for convenience.
Using the Software
The Uploader software has two modes of operation: Upload File, and File
Conversion. Upload File mode is used to transfer files to the DPS-475/575, while File
Conversion mode is used to convert still image files and animations into formats that
can be later uploaded.
201
To Next Page
Loading...