2. Use the control knob to select Recall, and press the Memory key again.
3. Use the control knob to select the desired profile from one of the 10 available
memory locations, and press Memory again. The Proc Amp settings will be
changed to those stored in the specified profile. In addition to the 10 memory
locations, you can select the Unity Values profile, which resets the Proc Amp
settings to factory preset unity.
User 1 and User 2
The User 1 and User 2 keys are user-programmable, and have no default function.
See the section User-Programmable Keys later in this chapter for instructions on
assigning these buttons to desired functions.
Option
On units in which an option module has been added, this key may be used to control
functions of that hardware option. Please see the documentation for your option
module for further details. If the option board does not require the Option key to be
used, it user-programmable, and has no default function. See the section User-
Programmable Keys later in this chapter for instructions on assigning this button to a
different function.
DV Control Mode
When a DV device (such as a deck or camcorder) is connected to the DPS-475/575
by IEEE-1394 (Firewire), transport control can be done from the front panel of the
unit.
To enable DV device control, select DV Control from the Main Menu. (To reach the
Main Menu, press the Enter button while the Idle Screen is displayed.) The display
will change to show the current time code of the DV device, as well as the transport
status (play, stop, etc.). While in DV mode, the normal functionality of the front panel
controls is replaced by DV device control.
If you look carefully at the front panel of the unit, you’ll see standard representations
of transport controls below many of the buttons. The buttons used for DV device
control are as follows:
Key Function
Luma Stop
Black Rewind/Scrub Backward
Chroma Play
Hue Fast-Forward/Scrub Forward
Memory Record (used in conjunction with Play)
Option Pause
Default Toggle the control knob between Jog mode and
Shuttle mode
The control knob functions as a jog or shuttle controller, depending on the currently
selected mode.
To exit DV Control Mode and return to normal operation, press the Exit key.
20
DPS-475/575 Service Manual
To Next Page
Loading...
