Chapter 6:
Menus: Audio Setup
DDPlex Gain-L
Adjusts the left audio gain for DigiDuplex mode. This setting will not be available
when DigiDuplex mode is not enabled.
Valid Range: -20.0 dB to 20.0 dB
Default Setting: 0.0 dB
Related Setting: DigiDuplex Mode (Video Setup menu)
Fixed Delay
Specifies the fixed delay to be added to the audio stream. The valid fixed delay range
is dependent on the currently selected Sample Rate.
Valid Range: 0.00 ms to 867.52 ms (96 kHz sample rate)*
0.00 ms to 1735.05 ms (48 kHz sample rate)
0.00 ms to 1892.78 ms (44.1 kHz sample rate)
0.00 ms to 2602.58 ms (32 kHz sample rate)
Default Setting: 0.00 ms
Related Setting: Auto Track, Pitch Change, Sample Rate,
96kHz AES/EBU Output
* The 96kHz sample rate is used when the audio Input selection is set to AES/EBU
and the 96kHz AES/EBU Output option (detailed later in this chapter) is enabled.
If the audio Input selection is set to anything other than AES/EBU and the 96kHz
AES/EBU Output option is enabled, the 48 kHz sample rate is used (but
AES/EBU Output is still 96kHz).
When Auto Track is enabled, the total audio delay will be the sum of the fixed delay
specified here, and the amount of Auto Track delay (the automatic delay of the audio
data to match the delay of the video data through the synchronizer).
In Op. Level-R
Selects the right input operating level for the analog audio input.
Valid Settings: +8 dBu, +4 dBu, 0 dBu, -4 dBu, -10 dBu
Default Setting: 0 dBu
Related Setting: Headroom-R
* The clipping level of the DPS-475/575 is +24 dBu. Hence, the sum of this setting
and Headroom-R cannot exceed +24 dBu. If this setting is changed, and the change
would cause the +24 dBu maximum to be exceeded, Headroom-R will automatically
be adjusted.
In Op. Level-L
Selects the left input operating level for the analog audio input.
Valid Settings: +8 dBu, +4 dBu, 0 dBu, -4 dBu, -10 dBu
Default Setting: 0 dBu
Related Setting: Headroom-L
47
To Next Page
Loading...