Chapter 5:
Menus: Video Setup
EDH Detection
Enables or disables the Error Detection Handling (EDH) polling for the SDI data
stream.
Valid Settings: Off, Poll On
Default Setting: Off
Related Setting: EDH Error Count
When this setting is off, EDH errors are neither detected nor reported, and the EDH
indicator on the front panel is off.
When this option is set to Poll On, EDH errors are detected, and the EDH indicator
will flash when EDH errors have been detected.
The actual count of EDH errors is reported in the EDH Error Count option detailed
later in this section.
EDH Error Count
Reports the count of EDH errors detected when EDH Detection (detailed earlier in
this section) is enabled. Turning the control knob clears the count.
Clamp Speed
Specifies the input video clamp speed.
Valid Settings: Normal, Fast
Default Setting: Normal
This option is only applicable when the selected input video source is Composite or
Component.
Normal sets the input video clamp to a 30-line time constant; Fast sets the input video
clamp to a 3-line time constant
Aux Output
Specifies whether the Auxiliary Red, Green, Blue, and Sync connections on the
Multi-I/O breakout cable will provide key channel output, or RGB(S) output.
Valid Settings: Main, Key
Default Setting: Main
Related Setting: Aux Sync/Comp, Aux Sync Level
When Main is selected, the Aux Red, Aux Blue, and Aux Green connections will
provide RGB output; the Aux Sync connection will provide sync (thus forming RGB-
S output) or an additional composite output, depending on the current setting of the
Aux Sync/Comp option detailed later in this section.
When Key is selected, the Aux Red, Aux Blue, Aux Green and Aux Sync connections
will provide key channel output (for routing to an external keyer), irrespective of the
current setting of the Aux Sync/Comp option.
41
To Next Page
Loading...
