Chapter 12:
Menus: System Config
Version Information
Reports the serial number of the unit and the version numbers (or dates) of the
firmware and field-programmable gate arrays of the unit, as well as any installed
option modules. The version numbers of the following are reported:
Flash Firmware (with checksum)
Video FPGA 525
Video FPGA 625
Audio FPGA
DV-Gear
Option Card
HTML Files
Boot EPROM
Extra Options
Warm Reset
Resets the DPS-475/575.
WARNING: the output video signals will be briefly interrupted (no output/sync)
during the reset.
Reset to Factory Defaults
Performs a factory reset by clearing the unit’s non-volatile memory.
You will be asked to Cancel or Confirm the factory reset.
WARNING: if you Confirm the factory reset, all configuration options will be
reset to factory defaults. All saved settings presets will be lost.
Enable Extra Options
Enables additional options that you have purchased for the DPS-475/575. An unlock
code, consisting of eight hexadecimal digits, will be provided to you when you
purchase the option; once the option is installed into the unit, this unlock code must
be entered here to enable the option.
The unlock code is entered using the Enter key and control knob. Pressing the Enter
key cycles through which digit position (1 to 8) is to be modified; the control knob
selects a new digit for that position.
Pressing the Exit key stores the unlock code. An error message will be reported if the
unlock code is invalid.
Factory Calibration
Adjusts the calibration of the DPS-475/575.
WARNING: DO NOT enter this menu unless instructed to do so by DPS
Technical Support. Modification of calibration parameters will affect video
performance, and may degrade operation of the unit.
83
To Next Page
Loading...
