Flash Memory Mgmt
This sub-menu provides backup, restore, and file management of the unit’s flash
memory. From this menu, stored files (images, animations, keyer settings, etc.) can be
deleted and renamed, and configuration settings can be backed up.
List Files
Displays a list of all user files stored in the unit’s flash memory, including still
images, animations, user-defined test patterns, keyer settings profiles, and
configuration backup profiles.
File management (including renaming and deleting) of these files can be done by first
selecting the file to manipulate. Select the file by scrolling through the list with the
control knob, and pressing the Enter key to select the highlighted file.
Information about the selected file will then be shown, including the file name, size,
and internal type code. Press Exit to return to the file listing, or select one of the two
file management options: Delete This File or Rename This File.
Delete This File will remove the file from the unit’s flash memory, making its
memory space available for additional files.
Rename This File will change the name the file is stored under. The new name can be
up to 23 characters long, and is set by using the Enter key and control knob. Pressing
the Enter key cycles through which character position (1 to 23) is to be modified; the
control knob selects a new character for that position. Two consecutive spaces are not
allowed; attempting to move to the next character position after a space will return to
the first character position. Pressing the Exit key stores the new file name.
Memory Usage
Reports the amount of flash memory installed in the unit, currently in use, available
for file upload, and fragmented (unusable).
Backup All Settings
Saves all current configuration parameters and settings into a file in flash memory.
The settings will be stored under the name NVBackupX, where X is the next
available free settings profile number. Settings files can be renamed or deleted from
the List Files option detailed elsewhere in this section.
Restore All Settings
Recalls configuration parameters and settings from a stored settings profile. Selecting
this option displays a list of stored settings profiles. The profile to be loaded is
selected by scrolling through the list with the control knob, and pressing the Enter
key to select the desired profile.
WARNING: all current configuration settings will be overwritten by those in the
stored profile.
82
DPS-475/575 Service Manual
To Next Page
Loading...