TSG
Selects the test pattern to be output when the Test Signal Generator is enabled.
Valid Settings: <list of test patterns>
Default Setting: this option has no default setting
Related Setting: Test Signal Out
When this option is selected, the display panel shows a list of available test patterns,
and indicates which one is currently selected (active). The current pattern is changed
by scrolling through the list with the control knob, and pressing the Enter key to
select a new pattern.
The list will include all built-in test patterns, and additional test patterns uploaded to
the unit by the user or grabbed from video. See Appendix B, “Test Signals,” for a list
of built-in test patterns. The Source ID Slide test pattern consists of Full Field Bars
behind the Source ID text specified in Source ID option of the System Config menu.
See Appendix D, “The Uploader Software” or Appendix F, “Ethernet Control”, for
instructions on uploading new test patterns to the unit, and Chapter 11, “Menus:
TSG/Image Grabbing,” for instructions on grabbing test signals from video. If the
Test Signal Generator is enabled when a new test pattern is selected, that pattern will
automatically be loaded, and the output switched to the new pattern.
Output Burst
Controls whether or not color burst will be provided in the output video signal.
Valid Settings: Auto-Yes, Auto-No, Force-Yes, Force-No
Default Setting: Force-Yes
When Force-Yes is selected, chroma burst will be provided in the output signal
irrespective of whether it is present in the input signal.
When Force-No is selected, chroma burst will not be provided in the output signal
irrespective of whether it is present in the input signal.
When Auto-Yes is first selected, chroma burst will initially be provided in the output
signal irrespective of whether it is present in the input signal; when the input signal
subsequently changes, the provision of chroma burst will automatically follow the
input signal (chroma burst will be provided in the output if and only if it is present in
the input).
When Auto-No is first selected, chroma burst will initially not be provided in the
output signal, irrespective of whether it is present in the input signal; when the input
signal subsequently changes, the provision of chroma burst will automatically follow
the input signal (chroma burst will be provided in the output if and only if it is present
in the input).
SDI Clip
Enables or disables the black clip level of the SDI video outputs.
Valid Settings: Yes, No
Default Setting: No
When this option is set to Yes, all levels below black (digital level 64) are clipped in
the SDI output; when set to No, digital levels below 64 are allowed.
40
DPS-475/575 Service Manual
To Next Page
Loading...
