Chapter 6:
Menus: Audio Setup
Audio test tones are generated by the unit when Test Tones are selected as the audio
input source from the front panel controls or the Input option of the Audio Setup
menu.
Test Freq-L
Selects the frequency of the left audio test tone. The maximum selectable test tone
frequency is dependent on the currently selected Sample Rate.
Valid Range: 100 Hz to 21.5 kHz (48 kHz sample rate)
100 Hz to 20.0 kHz (44.1 kHz sample rate)
100 Hz to 14.5 kHz (32 kHz sample rate)
Default Setting: 1000 Hz (channel 1)
2000 Hz (channel 2)
Related Setting: Sample Rate
Test Freq-R
Selects the frequency of the right audio test tone. The maximum selectable test tone
frequency is dependent on the currently selected Sample Rate.
Valid Range: 100 Hz to 21.5 kHz (48 kHz sample rate)
100 Hz to 20.0 kHz (44.1 kHz sample rate)
100 Hz to 14.5 kHz (32 kHz sample rate)
Default Setting: 2500 Hz (channel 1)
3000 Hz (channel 2)
Related Setting: Sample Rate
Balanced
Specifies whether the analog audio inputs are balanced (Yes) or unbalanced.
Valid Settings: Yes, No
Default Setting: Yes
Termination
Sets the analog input termination to 600Ω (600R) or high-impedence (High-Z).
Valid Settings: 600R, High-Z
Default Setting: High-Z
Stereo Mode
Selects which stereo mode will be used for the configuration of the left and right
outputs of the channel.
Valid Settings: Mono Sum, Stereo, Swap L-R, Mono-L, Mono-R,
Mute-L, Mute-R
Default Setting: Stereo
In Mono Sum mode, both the left and right output are comprised of the sum of the left
and right inputs, divided by 2 (i.e. (L+R)/2 ).
49
To Next Page
Loading...
