Chapter 12:
Menus: System Config
LED Brightness
Adjusts the brightness level of indicator LEDs on the front of the unit.
Valid Range: 0 to 15
Default Setting: 7
Idle Timeout
Adjusts the duration of time the unit waits before returning the display to the Idle
Screen, when the display has been left at another setting. For example, if the user
adjusts a parameter and leaves the display on the parameter setting screen, the unit
will return to the Idle Screen after the delay specified in this option. Any key press or
turn of the control knob starts the delay time over.
Valid Range: 10 seconds to 2500 seconds
Default Setting: 300 seconds
Idle Cycle Time
Adjusts the frequency at which information on the Idle Screen is refreshed. This
setting specifies the amount of time between each refresh.
Valid Range: 10 ms to 2500 ms
Default Setting: 50 ms
One-Time Video Setup
Source ID
Specifies the Source ID text. The text can be up to 23 characters long, and is set by
using the Enter key and control knob.
Pressing the Enter key cycles through which character position (1 to 23) is to be
modified; the control knob selects a new character for that position. Two consecutive
spaces are not allowed; attempting to move to the next character position after a space
will return to the first character position.
Pressing the Exit key stores the new Source ID.
Setup level (in)
Specifies whether or not the input video signal includes setup. This setting is not
applicable in 625-line mode [PAL].
Valid Settings: With, Without
Default Setting: With
Setup level (out)
Specifies whether or not setup should be included in the video output. This setting is
not applicable in 625-line mode [PAL].
Valid Settings: Add, No Setup
Default Setting: Add
77
To Next Page
Loading...