Leitch DPS-475 - Headroom-R; Headroom-L; Out Op. Level-R; Out Op. Level-L

* The clipping level of the DPS-475/575 is +24 dBu. Hence, the sum of this setting
and Headroom-L cannot exceed +24 dBu. If this setting is changed, and the change
would cause the +24 dBu maximum to be exceeded, Headroom-L will automatically
be adjusted.
Headroom-R
Specifies the right headroom -- the level between the input operating level (In Op.
Level-R) and the maximum input level (at which clipping may occur).
Valid Range: 0.0 dB to (24.0 - In Op. Level-R) dB *
Default Setting: 18.0 dB
Related Setting: In Op. Level-R
* The clipping level of the DPS-475/575 is +24 dBu. Hence, the sum of this
headroom setting and In Op. Level-R cannot exceed +24 dBu; the unit will not allow
a headroom setting that will exceed this maximum. If In Op. Level-R is changed, and
the change would cause the +24 dBu maximum to be exceeded, this setting will
automatically be adjusted.
Headroom-L
Specifies the left headroom -- the level between the input operating level (In Op.
Level-L) and the maximum input level (at which clipping may occur).
Valid Range: 0.0 dB to (24.0 - In Op. Level-L) dB *
Default Setting: 18.0 dB
Related Setting: In Op. Level-L
* The clipping level of the DPS-475/575 is +24 dBu. Hence, the sum of this
headroom setting and In Op. Level-L cannot exceed +24 dBu; the unit will not allow
a headroom setting that will exceed this maximum. If In Op. Level-L is changed, and
the change would cause the +24 dBu maximum to be exceeded, this setting will
automatically be adjusted.
Out Op. Level-R
Selects the right output operating level for the analog audio outputs.
Valid Settings: +8 dBu, +4 dBu, 0 dBu, -4 dBu, -10 dBu
Default Setting: 0 dBu
Out Op. Level-L
Selects the left output operating level for the analog audio outputs.
Valid Settings: +8 dBu, +4 dBu, 0 dBu, -4 dBu, -10 dBu
Default Setting: 0 dBu
Tone Level
Selects the output level of audio test tones.
Valid Range: -38.0 dBFS to 0.0 dBFS
Default Setting: -18.0 dBFS
48
DPS-475/575 Service Manual