Step 2. Carefully lift up the server with three people.
CAUTION:
Make sure three people are lifting the sever by holding the lift points
Rack front
Figure 54. Lifting up the server
1
Lift points
Step 3. From the front of the rack, install server into the rails.
Attention: You can only install the server successfully when the rails are fully extended.
a. Tilt the server and slowly lower the its rear end; then, push the rails toward the server and
make sure the farthest nailheads on server’s left and right side go into the slots on the rail.
b.
Slowly lower the server down and make sure the other 3 nailheads on server’s left and right
side slip into corresponding slots.
Step 4. Slide the server into rack.
96
ThinkSystem SR635 V3 User Guide
To Next Page
Loading...
