After you finish
Install a new OCP module or a card filler. See “Install the OCP module” on page 139.
Install the OCP module
Use this information to install the OCP module.
About this task
Attention:
• Read
“Installation Guidelines” on page 45 and “Safety inspection checklist” on page 46 to ensure that you
work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Note: If there is an OCP module installed, when the system is powered off but still plugged in to AC power,
fans 1 and 2 may continue to spin at a much lower speed. This is the system design to provide proper
cooling for the OCP module.
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
DrpxDWLMfgtXO4O6BVYTim
.
Procedure
Step 1. Touch the static-protective package that contains the OCP module to any unpainted surface on the
outside of the server. Then, take the OCP module out of the package and place it on a static-
protective surface.
Step 2. Attach the OCP module label that comes with this option on the rear of the server.
Figure 86. OCP module label installation
Chapter 5. Hardware replacement procedures 139
To Next Page
Loading...
