Step 4. Hold the two blue touch points and directly lift the rear drive cage out of the chassis.
Figure 118. Hot-swap rear drive cage removal
Step 5. If the rear backplane is reused, remove the rear backplane. See
“Remove the rear 2.5-inch drive
backplane” on page 64
.
After you finish
If you are instructed to return the old rear drive cage, follow all packaging instructions and use any packaging
materials provided.
Install the 2.5-inch rear drive assembly
Use this information to install the 2.5-inch rear drive assembly.
About this task
The following illustrates how to install the 2.5-inch rear drive assembly.
Attention:
• Read
“Installation Guidelines” on page 45 and “Safety inspection checklist” on page 46 to ensure that you
work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
DrpxDWLMfgtXO4O6BVYTim
.
Procedure
Chapter 5. Hardware replacement procedures 171
To Next Page
Loading...
