Lenovo ThinkSystem SR635 V3 User Manual

Remove the RAID flash power module on the system board tray
Use this information to remove the RAID flash power module on the system board tray.
About this task
Attention:
• Read
“Installation Guidelines” on page 45 and “Safety inspection checklist” on page 46 to ensure that you
work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
DrpxDWLMfgtXO4O6BVYTim
.
Procedure
Step 1. Remove the top cover. See
“Remove the top cover” on page 212.
Step 2. Disconnect the cable of the RAID flash power module.
Step 3. Remove the RAID flash power module on the system board tray.
Figure 110. Removal of the RAID flash power module on the system board tray
a.
Open the retention clip on the holder of the RAID flash power module.
b.
Take the RAID flash power module out of the holder.
164
ThinkSystem SR635 V3 User Guide

Lenovo ThinkSystem SR635 V3 Specifications

General

Brand	Lenovo
Model	ThinkSystem SR635 V3
Category	Server
Language	English