Step 4. Carefully lift the 2.5-inch rear drive backplane out of the rear hot-swap drive cage.
Figure 25. 2.5-inch rear drive backplane removal
After you finish
If you are instructed to return the old backplane, follow all packaging instructions and use any packaging
materials provided.
Install the rear 2.5-inch drive backplane
Use this information to install the 2.5-inch rear drive backplane.
About this task
Attention:
• Read
“Installation Guidelines” on page 45 and “Safety inspection checklist” on page 46 to ensure that you
work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
DrpxDWLMfgtXO4O6BVYTim
.
Procedure
Step 1. Touch the static-protective package that contains the rear backplane to any unpainted surface on
the outside of the server. Then, take the rear backplane out of the package and place it on a static-
protective surface.
66 ThinkSystem SR635 V3 User Guide
To Next Page
Loading...
