Step 2. Align the rear backplane with the rear hot-swap drive cage and lower it into the rear hot-swap drive
cage.
Figure 26. Rear backplane installation
Step 3. Connect the cables to the backplane. See Chapter 6 “Internal cable routing” on page 217.If the
cable connectors come with protective dust caps, make sure to remove them before plugging in.
Step 4. Install the air baffle into the rear hot-swap drive cage as shown.
Figure 27. Air baffle installation
a.
Align the air baffle edge with the notch on the drive cage.
b.
Press the air baffle down and make sure that it is seated in place.
Step 5. Connect the cables to the system board or expansion slots. See
Chapter 6 “Internal cable routing”
on page 217
.
After you finish
1. Reinstall drives or drive fillers into the rear hot-swap drive cage. See
“Install a 2.5-inch hot-swap drive”
on page 100.
Chapter 5. Hardware replacement procedures 67
To Next Page
Loading...
