a. Disconnect the cable of the intrusion switch from the system board. For the location of the
intrusion switch connector and cable routing information, refer to
“System-board-assembly
connectors” on page 33
and “Intrusion switch” on page 226. Route the cable out of the cable
clip.
b.
Insert the tip of a slotted screwdriver into the gap between the cage and switch and push
backward.
c.
Slide the intrusion switch as shown to remove it.
Step 4. Re-install the number 4 fan.
After you finish
If you are instructed to return the old intrusion switch, follow all packaging instructions and use any
packaging materials that are provided.
114
ThinkSystem SR635 V3 User Guide
To Next Page
Loading...
