Ensure that the module handle (LACM heat sink bracket) is installed when removing or installing the
LACM. Do not touch the radiator fins. Touching the radiator fins might damage the LACM.
Prepare the following screwdrivers to ensure you can install and remove the corresponding screws properly.
Torque screwdriver type list
Screw Type
Torx T20 screwdriver Torx T20 screw
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
DrpxDWLMfgtXO4O6BVYTim
.
Procedure
Step 1. Install the PSU air baffle. See
“Install a power supply unit air baffle baffle” on page 145.
Step 2. If you have removed the radiator tray, install the radiator tray to the chassis.
a. Place the tray evenly into the chassis and then move it to the right so that the screw hole on
the tray aligns with the hole on the chassis.
b.
Tighten the screw.
Step 3. Separate the LACM module from the shipping tray.
Chapter 5. Hardware replacement procedures 121
To Next Page
Loading...
