Note: Among 10 x 2.5" configurations, only 10 x 2.5" NVMe (Gen 4) supports closed loop heat sink. 10 x
2.5" AnyBay (Gen 4/ Gen 5) and 10 x 2.5" NVMe (Gen 5) do not support it.
Front bays Max.
Ambi-
ent
Temp.
(at sea
level)
Processor group (A, B, E) Heat
sink
Fan
type
• 10 x 2.5" NVMe
• 10 x 2.5" AnyBay
• 10 x 2.5" SAS/SATA
• 8 x 2.5'' SAS/SATA
• 6 x SAS/SATA + 4 x AnyBay
• 6 x SAS/SATA + 2 x AnyBay + 2 x
NVMe
35°C
B Perf Std
45°C
B Perf Perf
40°C
A Perf Perf
25°C E (except 9654/9654P processors) CL
note
Perf
30°C E CL
note
Perf
35°C E (9654/9654P/9174F/9554/9554P
processors only)
CL
note
Perf
25°C E (9654/9654P processors only) Perf Perf
16-EDSFF 30°C
A Perf Perf
• 4 x 2.5'' SAS/SATA
• 4 x 2.5'' NVMe
• 4 x 2.5'' AnyBay
45°C
B Perf Perf
40°C
A Perf Perf
30°C E (except 9654/9654P/9174F processors) CL Perf
25°C E (except 9654/9654P/9174F/9554/9554P
processors)
CL Perf
25°C E (9554/9554P processors) Perf Perf
30°C E (9174F/9654/9654P processors only) Perf Perf
35°C
E
CL Perf
Storage configurations: server models with rear bays
This section provides thermal information for the storage configuration when rear bays (2 x 2.5" SAS/SATA/
NVMe (U.2/U.3)) are installed.
Front bays
Max. Ambient
Temp.
(at sea level)
Processor group
Heat sink
Fan type
• 10 x 2.5" SAS/
SATA
• 10 x 2.5" NVMe
• 6 x 2.5" SAS/
SATA + 4 x 2.5"
AnyBay
30°C B Perf Perf
25°C A Perf Perf
25°C
E (9654/9654P
processors only)
Perf Perf
Notes:
• To support rear 2x2.5" SAS/SATA or NVMe (U.2/U.3) drives, the following conditions need to be met:
– Gen 4 low-profile riser installed in Riser 1
Chapter 5. Hardware replacement procedures 55
To Next Page
Loading...
