Attention:
• Read
“Installation Guidelines” on page 45 and “Safety inspection checklist” on page 46 to ensure that you
work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Procedure
Step 1. Touch the static-protective package that contains the EDSFF cage to any unpainted surface on the
outside of the server. And then, take the EDSFF cage out of the package and place it on a static-
protective surface.
Step 2. Slide the diagnostics panel assembly into the front chassis as shown. And ensure that it is seated in
place.
Figure 35. EDSFF cage installation
Chapter 5. Hardware replacement procedures 77
To Next Page
Loading...
