Note: Depending on the specific type, your backplane might look different from the illustration.
Some cables might need to be removed or moved to the side to remove the backplane. If needed,
record the cable connections on the backplane and then disconnect the cables from the backplane
first.
• 8-bay drive backplane
Figure 50. Removing the 8-bay drive backplane
1.
Lift the release tabs.
2.
Rotate the backplane from the top to disengage it from the two pins on the chassis.
• 24-bay drive backplane with expander
Chapter 5. Hardware replacement procedures 95
To Next Page
Loading...
