a. If the yellow drive status LED is lit continuously, that drive is faulty and must be replaced.
b. If the green drive activity LED is flashing, the drive is being accessed.
Step 4. Continue to install additional hot-swap drives if necessary.
After you finish
1. Reinstall the security bezel if you have removed it. See
“Install the security bezel” on page 238.
2. If the server is configured for RAID operation through a ThinkSystem RAID adapter, you might have to
reconfigure your disk arrays after you install drives. See the ThinkSystem RAID adapter documentation
for additional information about RAID operation and complete instructions for using ThinkSystem RAID
adapter.
Air baffle replacement
Follow instructions in this section to remove and install the air baffle.
The air baffle varies by the server hardware configuration. Refer to
“Thermal rules” on page 69 to select the
appropriate air baffle for your server. This topic uses the standard air baffle as an example for illustration. For
information about the GPU air baffle, see
“GPU replacement” on page 108.
•
“Remove the air baffle” on page 85
• “Install the air baffle” on page 87
Figure 42. Standard air baffle Figure 43. GPU air baffle
Remove the air baffle
Follow instructions in this section to remove the air baffle.
About this task
Chapter 5. Hardware replacement procedures 85
To Next Page
Loading...
