Figure 197. Removing the 8 x 2.5-inch rear drive cage
a. Twist and pull out the blue plungers.
b.
Slide the drive cage towards the rear of the chassis to release it.
Step 3. Hold the backplane and carefully lift the backplane out of the drive cage.
Figure 198. Removing the rear 8 x 2.5-inch drive backplane
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install the 8 x 2.5" drive backplane and drive cage
Use this information to install 2.5-inch 8-bay drive backplane and drive cage.
About this task
Attention:
• Read
“Installation Guidelines” on page 55 and “Safety inspection checklist” on page 56 to ensure that you
work safely.
226
ThinkSystem SR650 V3 User Guide
To Next Page
Loading...
