Remove the front I/O module
Use this information to remove the front I/O module.
About this task
Depending on the server model, the server might come with one of the following front operator panels:
1 Front operator panel without an LCD display
1 Front operator panel with an LCD display (called
integrated diagnostics panel)
Attention:
• Read
“Installation Guidelines” on page 55 and “Safety inspection checklist” on page 56 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 73.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
BmyijyY0-lNvapM4fTV5Gf
.
Procedure
Step 1. Make preparation for the task.
a. If the security bezel is installed, remove it. See
“Remove the security bezel” on page 237.
b. If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the
top cover, or remove the server from the rack. See
“Remove the server from rack” on page 73.
c. Remove the top cover. See
“Remove the top cover” on page 266.
d. Remove the air baffle. See
“Remove the air baffle” on page 85.
Step 2. Disconnect the cables of the front I/O module from the system board assembly.
Notes:
104
ThinkSystem SR650 V3 User Guide
To Next Page
Loading...
