Figure 276. Riser card 3/4 signal cable routing
From To
1 Swift connector 1 on riser card 3 PCIe 1 connector on the system board assembly
2 Swift connector 2 on riser card 3 PCIe 2 connector on the system board assembly
3 Swift connector 1 on riser card 4 PCIe 9 connector on the system board assembly
4 Swift connector 2 on riser card 4 PCIe 10 connector on the system board assembly
Backplanes: server models with 2.5-inch front drive bays
This section provides backplane cable connection information for server models with 2.5-inch front drive
bays.
Before you start
Ensure below parts are removed before starting cable routing for front backplanes.
• Top cover (see
“Remove the top cover” on page 266)
• Air baffle (see
“Remove the air baffle” on page 85)
• Fan cage (see
“Remove the system fan cage” on page 259)
Power cable connections
The server supports the following 2.5-inch drive backplanes:
Chapter 6. Internal cable routing 297
To Next Page
Loading...
