Ethernet connectors
Figure 9. OCP module (two connectors, seen from the
rear)
Figure 10. Ports on the OCP module (four connectors,
seen from the rear)
The OCP module provides two or four extra Ethernet connectors for network connections.
By default, one of the Ethernet connectors on the OCP module can also function as a management
connector using the shared management capacity.
Top view
This section contains information on the top view of the server.
The following illustration shows the top view of the server without any air baffle, middle cage, or rear cage
installed.
Figure 11. Server top view
Table 19. Component identification (Top view)
1 Front backplane(s)
2 Intrusion switch
3 System fans
4 Memory modules
Chapter 2. Server components 33
To Next Page
Loading...
