Signal cable routing
Figure 298. Signal cable routing to Trimode 16i adapter
From To
1 Backplane 1: SAS 16i adapter
• C0
2 Backplane 2: SAS
• C1
Two 8 x NVMe backplanes (Gen 4)
This section provides cable routing information for the server model with two 8 x 2.5-inch NVMe front drive
backplanes (Gen 4).
To connect power cables for the front backplane(s), refer to
“Backplanes: server models with 2.5-inch front
drive bays” on page 297
.
To connect signal cables for the front backplane(s), refer to the following cable routing scenarios depending
on your server configuration.
• “16 x NVMe” on page 316
• “12 x NVMe” on page 316
Chapter 6. Internal cable routing 315
To Next Page
Loading...
