Step 2. Touch the static-protective package that contains the new part to any unpainted surface on the
outside of the server. Then, take the new part out of the package and place it on a static-protective
surface.
Step 3. Install the memory module into the slot.
Attention:
• To avoid breaking the retaining clips or damaging the memory module slots, open and close the
clips gently.
• If there is a gap between the memory module and the retaining clips, the memory module has
not been correctly inserted. In this case, open the retaining clips, remove the memory module,
and then reinsert it.
Figure 100. Memory module installation
a. Gently open the retaining clip on each end of the memory module slot.
b.
Align the memory module with the slot, and gently place the memory module on the slot
with both hands.
c.
Firmly press both ends of the memory module straight down into the slot until the retaining
clips snap into the locked position.
After you finish
Complete the parts replacement. See
“Complete the parts replacement” on page 269.
MicroSD card replacement
Follow the instructions in this section to remove and install the MicroSD card.
• “Remove the MicroSD card” on page 140
• “Install the MicroSD card” on page 141
Chapter 5. Hardware replacement procedures 139
To Next Page
Loading...
