Figure 300. NVMe cable routing to onboard connectors
From To
1 Backplane 1: NVMe 0-1
Onboard: PCIe 8
2 Backplane 1: NVMe 2-3
Onboard: PCIe 7
3 Backplane 1: NVMe 4-5, 6-7
Onboard: PCIe 6, 5
4 Backplane 2: NVMe 0-1, 2-3
Onboard: PCIe 3, 4
One 8 x SAS/SATA and one 8 x AnyBay (Gen 4) backplanes
This section provides cable routing information for the server model with one 8 x 2.5-inch SAS/SATA
backplane and one 8 x 2.5-inch AnyBay backplane (Gen 4).
To connect power cables for the front backplane(s), refer to
“Backplanes: server models with 2.5-inch front
drive bays” on page 297
.
To connect signal cables for the front backplane(s), refer to the following cable routing scenarios depending
on your server configuration.
• “Onboard connectors + 8i RAID/HBA adapter” on page 318
• “Onboard connectors + 16i RAID/HBA adapter” on page 319
• “Onboard connectors + CFF 16i RAID/HBA adapter” on page 321
Chapter 6. Internal cable routing 317
To Next Page
Loading...
