Figure 225. System fan cage installation
Step 1. Align the system fan cage with the mounting guides on both sides of chassis, and lower it into the
chassis.
Step 2. Rotate the fan cage levers down until the fan cage clicks into place.
Note: If there are system fans installed in the system fan cage, ensure that the system fans are
correctly connected to the system fan connectors on the system board assembly.
After you finish
1. If you have removed the system fans, reinstall them. See
“Install a system fan” on page 256.
2. Complete the parts replacement. See “Complete the parts replacement” on page 269.
Serial port module replacement
Use this information to remove and install a serial port module.
Remove a serial port module
Use this information to remove a serial port module.
About this task
Attention:
• Read
“Installation Guidelines” on page 55 and “Safety inspection checklist” on page 56 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 73.
Chapter 5. Hardware replacement procedures 261
To Next Page
Loading...
