Figure 183. 7mm SSD riser cage removal
Step 3. (Only for the 2FH+7mm SSD riser cage) Remove the 7mm drive cage from the riser assembly.
Figure 184. 7mm drive cage removal
a. Remove the two screws.
b.
Slightly and horizontally slide the cage out of the riser cage.
After you finish
Remove the two 7mm backplanes. See
“Remove the 7mm drive backplanes” on page 215.
Remove the 7mm drive backplanes
Use this information to remove the 7mm drive backplanes.
About this task
Attention:
• Read
“Installation Guidelines” on page 55 and “Safety inspection checklist” on page 56 to ensure that you
work safely.
Chapter 5. Hardware replacement procedures 215
To Next Page
Loading...
