Install the server to rack
Follow instructions in this section to install the server to the rack.
S036
18 - 32 kg (39 - 70 lb) 32 - 55 kg (70 - 121 lb)
CAUTION:
Use safe practices when lifting.
R006
CAUTION:
Do not place any object on top of a rack-mounted device unless that rack-mounted device is intended
for use as a shelf.
CAUTION:
• Potential stability hazards exist. The rack might tip over and cause serious personal injury.
• Before extending the rack to the installation position, read the
“Installation Guidelines” on page 55.
Do not put any load on the slide-rail mounted equipment in the installation position. Do not leave
the slide-rail mounted equipment in the installation position.
About this task
Attention:
• Read
“Installation Guidelines” on page 55 and “Safety inspection checklist” on page 56 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 73.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
CAUTION:
Make sure to have three people operate the server installation procedures to prevent injury.
Firmware and driver download: You might need to update the firmware or driver after replacing a
component.
• Go to
https://datacentersupport.lenovo.com/products/servers/thinksystem/sr650v3/7d75/downloads/driver-
list/
to see the latest firmware and driver updates for your server.
• Go to “Update the firmware” on page 445 for more information on firmware updating tools.
Chapter 5. Hardware replacement procedures 77
To Next Page
Loading...
