EasyManua.ls Logo

Lenovo ThinkSystem SR650 V3 7D75 - System-Board-Assembly Switches

Lenovo ThinkSystem SR650 V3 7D75
518 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5 Serial port connector 6 Rear USB connectors
7 Second management Ethernet connector 8 XCC system management port
9 Internal USB connector
10 Riser 1 slot
11 OCP 3.0 slot 12 CMOS battery (CR2032)
13 M.2 power connector 14 Leak detection connector
15 Front USB connector
16 7mm backplane power connector
17 PCIe connector 3
18 Fan connectors
19 Front I/O connector (for Y cable) 20 Front I/O connector
21 Backplane 3 power connector
22 PCIe connector 1
23 PCIe connector 2
24 Backplane 2 power connector
25 PCIe connector 4 26 CFF Retimer connector
27 CFF expander power connector
28 Intrusion switch connector
29 Backplane 1 power connector
30 PCIe connector 6
31 CFF RAID/HBA power connector 32 PCIe connector 7
33 PCIe connector 8
34 External diagnostics connector
35 Front VGA connector 36 PCIe connector 5
37 Riser 3 sideband connector
38 PCIe connector 9
39 PCIe connector 10
40 Power supply 1 connector
41 Riser 3 power connector 42 Power supply 2 connector
43 GPU power connector
44 Riser 2 slot
45 Firmware and RoT security module connector
46 SATA connector 0
47 SATA connector 1 48 SATA connector 2
49 M.2/7mm backplane signal connector
50 Backplane power connector
51 Backplane sideband connector
Notes:
The front I/O module on rack latch is connected to connector
20 . See “Front I/O connectors” on page
279
.
The front I/O module on media bay with an integrated diagnostics panel (an LCD diagnostics display) is
connected to connector
20 . See “Front I/O connectors” on page 279.
The front I/O module on media bay without LCD diagnostics display is connected to connectors
19 and
20 using a Y cable. See “Front I/O connectors” on page 279.
System-board-assembly switches
The following illustrates locations and functions of the switch block on the on the system board assembly
which contains the system I/O board and processor board.
Important:
1. Before you change any switch settings or move any jumpers, turn off the server; then, disconnect all
power cords and external cables. Review the following information:
36
ThinkSystem SR650 V3 User Guide

Table of Contents

Related product manuals