Figure 166. Supercap holder removal
a. Lift the latch.
b.
Slide the supercap holder in the shown direction and lift it out of the chassis.
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install a RAID flash power module on the chassis
Use this information to install a RAID flash power module (also called supercap) on the chassis.
About this task
Attention:
• Read “Installation Guidelines” on page 55 and “Safety inspection checklist” on page 56 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 73.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
BmyijyY0-lNvapM4fTV5Gf
.
Procedure
200 ThinkSystem SR650 V3 User Guide
To Next Page
Loading...
