Figure 192. 7mm SSD riser cage installation
Step 4. Connect the cables from the backplanes to the system board assembly. See
Chapter 6 “Internal
cable routing” on page 271
.
After you finish
1. Reinstall all the drives and fillers (if any) into the drive bays. See
“Install a hot-swap drive” on page 83.
2. Complete the parts replacement. See
“Complete the parts replacement” on page 269.
Rear drive backplane and drive cage replacement
Use this information to remove and install rear drive backplanes and drive cages.
•
“Remove the 4 x 2.5" drive backplane and drive cage” on page 221
• “Install the 4 x 2.5" drive backplane and drive cage” on page 223
• “Remove the 8 x 2.5" drive backplane and drive cage” on page 225
• “Install the 8 x 2.5" drive backplane and drive cage” on page 226
• “Remove the 2 x 3.5" drive backplane and drive cage” on page 228
• “Install the 2 x 3.5" drive backplane and drive cage” on page 230
• “Remove the 4 x 3.5" drive backplane and drive cage” on page 232
• “Install the 4 x 3.5" drive backplane and drive cage” on page 234
Remove the 4 x 2.5" drive backplane and drive cage
Use this information to remove the rear 2.5-inch 4-bay drive backplane and drive cage.
About this task
Attention:
• Read “Installation Guidelines” on page 55 and “Safety inspection checklist” on page 56 to ensure that you
work safely.
Chapter 5. Hardware replacement procedures 221
To Next Page
Loading...
