Attention:
• Read
“Installation Guidelines” on page 55 and “Safety inspection checklist” on page 56 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 73.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
• For PCIe adapter installation rules, see
“PCIe slots and PCIe adapters” on page 64.
Firmware and driver download: You might need to update the firmware or driver after replacing a
component.
• Go to
https://datacentersupport.lenovo.com/products/servers/thinksystem/sr650v3/7d75/downloads/driver-
list/
to see the latest firmware and driver updates for your server.
• Go to
“Update the firmware” on page 445 for more information on firmware updating tools.
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
BmyijyY0-lNvapM4fTV5Gf
.
Procedure
Step 1. Touch the static-protective package that contains the new part to any unpainted surface on the
outside of the server. Then, take the new part out of the package and place it on a static-protective
surface.
Step 2. (Optional) If you have removed the riser card, install the riser card first.
• Riser card 1 (same for riser card 2)
Note: The following uses the 3-slot riser cage as an example for illustration. The replacement
procedure for the 1-slot riser cage is similar.
Figure 125. Installing the riser card to riser 1 cage or riser 2 cage
a. Align the riser card with the riser cage and put it into the riser cage.
b.
Install two screws to secure riser card into place.
• Riser card 3
Chapter 5. Hardware replacement procedures 163
To Next Page
Loading...
