Lenovo ThinkSystem SR650 V3 7D75 - Page 192

Figure 143. Separating a processor from the heat sink and carrier
Note: Do not touch the contacts on the processor.
a.
Lift the handle to release the processor from the carrier.
b.
Hold the processor by its edges; then, lift the processor from the heat sink and carrier.
c.
Without putting the processor down, wipe the thermal grease from the top of the processor
with an alcohol cleaning pad; then, place the processor on a static protective surface with the
processor-contact side up.
Step 2. Separate the processor carrier from the heat sink.
Figure 144. Separating a processor carrier from the heat sink
Note: The processor carrier will be discarded and replaced with a new one.
a.
Release the retaining clips from the heat sink.
b.
Lift the carrier from the heat sink.
c.
Wipe the thermal grease from the bottom of the heat sink with an alcohol cleaning pad.
After you finish
182 ThinkSystem SR650 V3 User Guide