Note: To prevent the contact of the system I/O board from damage, ensure that the system I/
O board is aligned correctly with the connector on the processor board, and remains as
horizontal as possible during the insertion.
b. Install the screws to fix the system I/O board into place.
Step 4. Install the system board assembly into the server.
Figure 221. System board assembly installation
a. Insert the front end of the system board assembly towards the front of the chassis until it
stops.
b.
Lower the other end down into the chassis.
c.
Slide the system board assembly towards the rear of the chassis until it clicks into place.
Ensure that rear connectors on the system I/O board are inserted into the corresponding holes
in the rear panel.
After you finish
1. Install any components that you have removed:
•
“Install a processor and heat sink” on page 183
• “Install a memory module” on page 138
• “Install the CMOS battery” on page 92
• “Install an internal RAID/HBA/expander adapter” on page 121
• “Install a RAID flash power module on the chassis” on page 200
252
ThinkSystem SR650 V3 User Guide
To Next Page
Loading...
